Similar
this weekBrazoria, TX+8 milesBoats for Sale
Strong running motor. Still has a lot of life. Only reason I m selling is to get a bigger motor. Great compression on all 3 cylinders. Power tilt and trim works. Stainless prop. Title in hand Can see it run by appointment. Feb 2018 - all 3 carbs reworked New stator and voltage regulator. Ignition tune up. Nov 2018 - new water pump kit installed. Comes with remote and all cables. Wire harness.
16ft aluminum boat. 25hp Yamaha that runs great. Runs about 30mph on the water. It's got a 12 gallon gas tank. Its has a trolling motor. Storage compartment up front. Good radio and speakers hooked up sounds good. Bilge pump is hooked up and works good if ever needed. Boat does not leak. Light bar and running lights work and are wired with a simple switch in the back. Trailer is decent has new ...
Pretty new matching tires (Michelin), 4 cylinder, cold a/c, auto, all power, great shape. Clear coat peeling in some places. Couple of spots of rust on hatch. Lots of spares= fuel pump, window motor, distributor caps, air filters, oil filters. Tags out. Runs great
$3,500

2000 Audi

2000 Audi TT Quattro, has a short somewhere I don't have the time to find it. I'm looking for a good truck. Car is titled and registered. Stickers are good until September. It has my disabled plates with it and I'm removing them from the car along with the sticker. You'll need a temporary plate from the state for travel from one point to another, we can print out at time of trade or purchase. $...
days agoAngleton, TX+14 milesCars for Sale
82k miles, excellent condition on the outside. The seats look almost new, new water pump, new wiper motor. One owner and bought new. Oil changed every 3500 miles. Could use some work around the dash in areas.
One is a 6hp tiller just needs a fuel pump put on it. The other is a 35hp Johnson runs good but need better way to attach the starter. Bolt that mounts it broke and put jb weld to hold it now. It's not a tiller and will need cables and controls for it. $350 for both
One is a 6hp tiller just needs a fuel pump put on it. The other is a 35hp Johnson runs good but need better way to attach the starter. Bolt that mounts it broke and put jb weld to hold it now. It's not a tiller and will need cables and controls for it. $350 for both
days agoAngleton, TX+14 milesFor Sale
CUSTOM BUILT 2003 EL PESCADOR 24 FT (VICTORIA EL PESCADOR, INC) 2003 YAMAHA DX150TLRB (DUAL COUNTERROTATING STAINLESS PROPS) http://www.sonsofdewittcolony.org/elpescador.htm A tunnel rear and jack plate motor control combined with a deep bow combines extremely shallow water manuevers together with a dry ride and unsurpassed seaworthiness while cruising in a single boat. It is great for co...
Selling my 2004 BMW 330Ci ZHP. Very clean car, garage kept. The ZHP package adds 18" wheels, M-Sport body kit, suede steering wheel and shift boot, charcoal headliner, M3 Suspension components, different cam and exhaust(raising the HP by 10 and the redline to 6800 rpm), higher stall torque converter and a few other things I'm sure i'm missing. This car is stock other than a high end after marke...
4,000 or best offer. Built cammed LS1: camshaft, all bearings, main studs, gaskets, lifters, pushrods, double beehive .600+ lift springs, high pressure melling oil pump, low profile oil pan, and LS1 intake and throttle body are all brand new. Camshaft is a Tick Performance grind 214/224 | .571"/.561" | LSA114+4. Block was cleaned and redone by South Houston engines and has new cam bearings and ...
1 + ... Next >